Again as suggested, it's best and highly suggested that the breaker is shut off, but safety steps still need to be observed. Something that I do, is always assume I'm stubborn (thanks mom) and the only thing I've gained from this board is a
Find Collinsville, OH Swingers sex, milfs galleries, Swinger couples seeking sex great friendship Otherwise I don't think this board has effectedly me negatively it's funny and I don't take it very seriously, I come here for kicks (and to not do my homework)
Married ladies looking sex tonight Santa Fe that the wire has power and handle accordingly. You should have 3 wires coming from your power source. Hot, (usually black),Neutral (usually white),and the ground (usually green). If possible, leave the wiring as it can be coiled up inside the base as you complete securing the base. Now, even if you have cut the power, place wiring nuts on all, just in case. Start with the ground wires from your source and the fan, and wire nut together. Now a little secret.. take some electrical tape and secure the nut to the wire by wrapping the tape around both in the tightening direction, starting on the nut. There is no way that it work it's way off. If your power source does not have a ground wire, take the fan ground wire and screw it to the mounting base that is screwed to the support stud. Now, cut about " off of the hot wire. IF, for some unknown reason the fan ever falls down, the last wire to disconnect be the ground. Repeat the wire nut process with the neutral and then the hot wire lastly. Once you have completed the wiring, make sure that you coil up any excess wiring and position it in a manner that it not get pinched when securing the fan to the base. Take one of the mounting screws that actually came with the fan, and you can lift the fan close enough to the base to get that screw started. Repeat with a second mounting screw. You can now safely the extra screw(s) that was holding the fan up while you wired it, and install the last of the mounting screws. Continually check to ensure that none of the wiring is potentially going to get pinched as this short out the power (and sparks are not fun,lol) Finish tightening up the mounting screws, tightening each screw a little at a time, so that the fan is being evenly lifted, until all are tightened securely. I that this was helpful and not to boring, lol. My ocd won't let me give you the sort version, heheh. Good Luck and let us know it goes :)